Maintain the oil level at 20~25 mm (3/4”~1”) below the lip of (black cap) port (see diagram below). Then remove the black cap shown in the diagram below. This is necessary to access the fill port (black cap) located under the pulley and fan (see diagram below).Īfter removing the unit from the vehicle, place the transaxle on a level surface and remove the fan and pulley. If checking the oil level/condition, it may be necessary to remove the transaxle from the vehicle. Normally the model K46 & T40A transaxles, that are featured in many tractor and rider models, do not require any servicing for the life of the vehicle. Tuff Torq Oil Service Procedure for Residential IHT units with Internal Reservoir Tank Models covered by this procedure:
